image description


Forum Index » Profile for rockylowther » Messages posted by rockylowther
Author
Message
All Other PreSonus Hardware » Monitor Station Levels Don't Match Pro Tools Meter Level » Go to message
ok… after using the Monitor Station V1 now for a couple days.
I'm finding the meters aren't very accurate. They're close but not accurate.
When my Daw hits -3 DBFS the MS is peaked out in the red.
I did exactly what the manual said and they did calibrate.
I'm a little disappointed and now I'm wondering if the V2 is the same.
Maybe I'm just too particular but I want all my meters to read exactly the same.
All Other PreSonus Hardware » Monitor Station Levels Don't Match Pro Tools Meter Level » Go to message
Thanks, That worked.
I had to reeeaaaddd it slowly and let it sink in this head of mine.
Again thanks
Pre-Sales Questions » my question, unanswered » Go to message
My Monitor Station shows registered.
Where was the thread moved to?
I still couldn't access the link sent to me.

When I try to access the page I get this:
Oooops. You don't have sufficient privileges to access this message
Pre-Sales Questions » my question, unanswered » Go to message
I posted a question in the "StudioLive General Discussion" thread and now I can't access the thread but can access all other threads.
What's up with that?
All Other PreSonus Hardware » Monitor Station Levels Don't Match Pro Tools Meter Level » Go to message
I didn't know where to post this. I'm new to the forum.
I'm using Pro Tools 10.3.8 with HDX card, 192 Analog and a Mac Pro Intel.
I switched from a Mackie Big Knob to a Presonus Monitor Station V1.
The level meters on the Monitor Station are Peaked out almost continually.
Is there anyway to adjust the Monitor Station's main source input level to match my Pro Tools meter level?
Never had this problem with the Mackie Big Knob.
 
Forum Index » Profile for rockylowther » Messages posted by rockylowther