image description


Two FP10's Use CR Outputs individually
  Forum Index » Inspire, Firebox, FP10 (Firepod) 
Author
Message
harryevan
Prenoob
[Avatar]

Joined: 01/08/2010 19:34:51
Messages: 17
Location: Carr, CO
Offline

I've been able to move to a W7 64-bit laptop using two FP10's (so far, so good). Using Studio One Artist, can I assign separate outputs to each FP10, individually? I'd like to try to utilize groups or sends and direct them to CR outputs 1&2 on FP10 #1 as left and right for one stereo output and CR outputs 1&2 on FP10 #2 as left and right for a different stereo output? Is that possible or am I AFU again?

harryevan

2 FP10's
Studio One Artist on
a Toshiba A215
with an internal TI Firewire chipset
and 4 GB RAM
running Windows 7 64-bit
harryevan
Prenoob
[Avatar]

Joined: 01/08/2010 19:34:51
Messages: 17
Location: Carr, CO
Offline

Maybe I'm looking at this wrong. I was under the impression that, on the FP10, each channel out is basically tied to the corresponding input, as a pass through output. Are they, instead, assigned by Studio One as stereo pairs? If this is true, I can create sends and/or groups that can be assigned to those pairs? Given that I have two daisy-chained FP10s, I essentially have eight pairs of stereo outputs at my disposal, correct?

So what would be the difference in the two sets of CR Main outputs? i.e., would the signal from the CR outputs on FP10 #1 be different from the CR outputs on FP10 #2?
harryevan

2 FP10's
Studio One Artist on
a Toshiba A215
with an internal TI Firewire chipset
and 4 GB RAM
running Windows 7 64-bit
 
Forum Index » Inspire, Firebox, FP10 (Firepod)
Go to: