Softube Saturation Knob

Screen Shot 2014-06-18 at 11.44.42 am.png

It might also have been possible to Open Studio One at the start Page go to the Studio One Menu and Opened the Extensions Dialog and ran the Install from there.. There is an Instal Button on that screen..

Ahhh,, does that direct to My Account online or to a folder ?

And I see something interesting on yours,, lol
Soundset builder and I think the Marco Toolbar is on Exchange ?
I get the Marco and that was my next thing to set up,,, but haven't looked at exchange just yet..

This message was edited 3 times. Last update was at 18/06/2014 12:16:02

To a Folder..
It asks you basically to tell it what you want to install and to point to a installer file..

If you download direct from Exchange via the S1 Browser it will normally automatically install..
If not then the files normally get downloaded to the default downloads directory and you can "manually" install them yourself.

If you download from the Web version of Exchange then you have to manually do the install.. By either drag and drop or using that Install button..

Oh and if you manually install you may also have go push the Enable button.

When I instal Manually I also usually go out of Studio Oe and restart it so that it will pick up the installed extension properly. Just a habit I have gotten into.

Give it a go...

the way i always install it when i redo drives... is without S1 running (but installed) double click the knob's .install file which will start S1 since the .install file is associated with S1. it will then ask you if you want it installed. cheers

jay

With me it says its installed, but do you think I can find it anywhere...NO!!!
So I do not have a clue where to use it from...

It's way down near the bottom of your plugin list. I believe it's just called "Saturation Knob".

This message was edited 4 times. Last update was at 18/06/2014 13:38:24

if installed... browser... effects... Softube heading... Sat knob

i use it a lot of times on the bass to warm the signal coming out of amp sim to master or bus.

This message was edited 1 time. Last update was at 18/06/2014 21:35:45

mine shows it is a VST3, so in effects viewing Folders,
VST3 > Distortion > Saturation Knob

All sorted, had a bad install for some reason, re did it and all is fine now.

well i have my common files VST3 folder (which is default i think for VST3) as a plugin path. sry if i was confusing...

oldblood wrote:All sorted, had a bad install for some reason, re did it and all is fine now.

Good to hear.